視頻
    視頻
  • 1/2
13525000476
產品詳情

Tire sidewalls cutter can decompose the sidewalls of the tire with the crown, providing faster processing for subsequent process and lower producing cost. Different tires specification require customized tire sidewalls cutting machine.


Tire sidewalls cutting machine is one of the tire decomposition parts (sidewalls cutting machine, strip cutting machine and blocks cutting machine). Its function is to cut off the ring mouth of waste tire containing thick steel wire for further crushing.


This machine is used to cut off one side of the tire so that the lower part can be disassembled for use. Place the tire on the rotary table, lock the connecting rod mechanism, fix the inner opening of the tire firmly, start the machine, grasp the handle, push the rotating arm, place the knife near the tire top (pay attention to adjusting the upper limit screw of the column), and slowly lower the knife. If the tire burst is serious and the exposed part of the steel wire cannot be cut, it shall be removed and cut off with a grinding wheel cutting blade.


Technical Data


ModelMotor
(kw)
Processing range
(mm)

Weight

(kg)

Dimension

(mm)

Production

(t/h)

QKF850/11502.2750-12005001300*900*14802
QKF150041200-15007502020*1500*19202



(Remarks:1. When cutting on one side, try to cut the flat tire side. If it is necessary to cut on both sides, please inform the manufacturer;2. If you have any help, please contact the manufacturer in time.)


Supporting equipment of waste tire sidewalls cutter:

1. The equipment can also be used with strips cutter and blocks cutter to break tire blocks.

2. The tire after the bead is cut off by the equipment can also be directly broken into tire blocks by a tire shredder.

3. It can be used with rubber crusher to form a rubber particle production line.

4. It can be used together with rubber breaker and fine rubber powder grinding machine to form rubber powder grinding production line.

5. In addition, screening machine, conveyor belt feeding, magnetic separator can also be used together with ring cutting machine to form corresponding rubber powder production line.


Instructions for use:

1.This machine is used for the treatment of 750 ~ 1200mm waste tires. The size is reasonably adjusted according to the tire specification to make the inner opening of the tire just put in. When the tire is placed on the rotary table, the hand wheel must be rotated and tightened to support the inner opening of the tire. Adjust the four fixing bolts on the beam so that the tool tip is just at the cutting position and the tool tip should be at the tangent point (a reasonable position directly affects the tool wear). After adjustment, the fastening bolts must be tightened.


2.Rotate the cross beam so that the knife tip is just at the part to be cut (as close to the tire top as possible). Note that the bolt should be adjusted to the appropriate strength so that the beam can be pushed. It shall not be too loose, so as not to cause large vibration, damage or affect the service life of the tool. Adjust the bolt so that the working position of the tool tip is just right. This bolt is a mechanical limit, and each specification of tire only needs to be adjusted once.


3.Rotate the handle and lower the knife slowly. After contacting the tire, grasp the handle to avoid knife vibration as far as possible until the sidewall is separated. The cutting time is generally about 20 seconds. After completion, rotate the beam away from the upper part of the tire to remove it.


4.The power adopts a closed rotating structure. The reducer is inspected once a half year and the grease or lubricating oil is replaced. Other parts: gear rack, beam rotating shaft, locking nut and hinge mechanism shall be lubricated at least once a week.